This adaptor cable will convert TWO USB A type sockets
into a 10 pin header.
One end of the cable has two USB A plugs. These can be plugged
into any USB A sockets on your system or a standard USB Hub.
The other end of the cable has a 10 pin header. The cables from your
internal USB devices can be connected to this header.
Please note cable may be a different colour to that shown in the picture.
The adaptor cables are USB 2.0 and approximately 24cm (9.5 inches) long.
These cables are designed for use in situations where your USB devices
already have cables and you just need an extra pin header adaptor to
If you do not have cables for your devices you should consider our USB A to pin header
cables which are long enough to connect your devices directly to
a spare USB A socket on your system.
Important note - Configuring the adaptor cables
Unfortunately there is no standard for the layout for the pins on a USB
pin header connector.
This means that you will need to configure the
pins in the 10 pin header to suit your own equipment.
The cable is supplied with the pins removed from the connectors.
need to do to configure the cable is insert the pins into the connectors
in the order required by your USB devices and then fit the supplied
You can find help on configuring USB cables and adaptors at the support section of our site.